- #White unibody 2010 macbook logic board replacement pro
- #White unibody 2010 macbook logic board replacement Bluetooth
#White unibody 2010 macbook logic board replacement Bluetooth
Fold the AirPort / Bluetooth ribbon cable back to keep it out of the way of the logic board.ĭisconnect the iSight cable by pulling its connector toward the optical drive opening. Use the flat end of a spudger to pry the AirPort / Bluetooth ribbon cable up off its socket on the logic board. Remove the right fan from the upper case. It is useful to twist the spudger axially from beneath the fan cable wires to release the connector. Use the flat end of a spudger to pry the right fan connector up out of its socket on the logic board.
Remove the three T6 Torx screws securing the right fan to the upper case. The layout of the logic board shown in the second picture may look slightly different than your machine but the fan socket is the same. Be careful not to break the plastic fan socket off the logic board as you use your spudger to lift the fan connector straight up and out of its socket. The fan socket and the fan connector can be seen in the second and third pictures. Use the flat end of a spudger to disconnect the left fan connector from the logic board. In some models, these T6 Torx screws may be 3.1 mm long. Remove the three 3.4 mm T6 Torx screws securing the left fan to the logic board. Pull the battery cable connector away from the center of the logic board. Pull the battery cable connector away from its socket on the logic board and remove the battery from the upper case. Tilt the battery away from the logic board enough to access the battery cable connector. Do not try to completely remove the battery just yet. Lift the battery by its plastic pull tab and slide it away from the long edge of the upper case.
Remove the last 7.4 mm Tri-point screw securing the battery to the upper case. Use the tip of your finger to carefully peel back the corner of the warning label to reveal a hidden Tri-point screw. However it is recommended to remove all power sources from electronics before working on them. You do not necessarily have to follow steps 3-6 to remove the battery in order to replace the hard drive. If you do not remove the battery, please be careful as parts of the motherboard might be electrified. hard drive), removing the battery is not necessary but it prevents any accidental shorting of electronics on the motherboard. Remove the two 7.4 mm Tri-point screws securing the battery to the upper case. Using both hands, lift the lower case near the vent to pop it off two clips securing it to the upper case. Remove the following ten screws securing the lower case to the upper case: T6 Torx Screwdriver (1) Tri-point Y0 Screwdriver (1)
#White unibody 2010 macbook logic board replacement pro
MacBook Pro 15" Unibody (Mid 2010) 2.66 GHz Logic Board (1) MacBook Pro 15" Unibody (Mid 2010) 2.53 GHz Logic Board (1) MacBook Pro 15" Unibody (Mid 2010) 2.4 GHz Logic Board (1) This requires removal of every component attached to the logic board. INTRODUCTION Use this guide to replace your bare logic board.
MacBook Pro 15" Unibody Mid 2010 Logic Board Replacement Replace the logic board in your MacBook Pro 15" Unibody Mid 2010. MacBook Pro 15" Unibody Mid 2010 Logic Board Replacement